Config ECM IPv6
Setting up target networking for IPv6 on ECM can be done through the host or directly on the target.
This host code sample uses a /127 prefix (only 2 addresses, 0 & 1):
$ sudo ip -6 addr add fd42::0 dev usb0 $ sudo ip -6 route add fd42::/127 dev usb0
To test the connection from the host to the target, run:
# ping6 fd42::0
Here's the same code sample that you run on the target:
# ip -6 addr add fd42::1 dev usb0 # ip -6 route add fd42::/127 dev usb0
To test the connection from the target to the host, run
$ ping6 fd42::1
To permanently setup addresses on both sides, add the following to /etc/network/interfaces
on the target:
auto usb0 iface usb0 inet6 static address fd42::0 netmask 127
Copyright (C) Sierra Wireless Inc. Use of this work is subject to license.